Electrical accessories for electric and water coil heaters

Electrical accessories for electric and water coil heaters

Range of Electrical accessories for electric and water coil heaters

  • At S&P we offer a wide range of accessories, including electrical accessories for heating coils.

    Among the different elements that you can find for heating coils are: regulators, power amplifier modules, room temperature sensors, potentiometers or timers.

    Discover the different electrical accessories for heating coils from our catalogue of electrical accessories and complement the heating coils of your ventilation systems.


  • PULSER, electronic single-phase/three-phase controller for heating coils

    The single-phase/three-phase electronic controllers for heating coils in the PULSER range are designed to maintain room temperature as a function of the selected temperature. These electronic impulse controllers adjust directly to the electrical battery power and work as a proportional time control system.


    PULSER-ADD, supplementary regulator for coils of more than 3600W - 230V

    The electronic regulators for heating coils of the PULSER-ADD range are designed to control coils of more than the capacity of the PULSER 3600W - 230V.


    PULSER M, electronic controller with setpoint temperature of 0-30ºC

    The PULSER M range of electronic regulators are designed for single-phase fuse protected voltage regulators of the REB 5-10 series. They have a surface application and a separate stop/start switch.


    PULSER D, single-phase electronic controller 16 A

    The single-phase 16 A regulators of the Pulser D range have a setpoint temperature of 0-30º. They are designed to mount in a cabinet on DIN rail and have IP20 protection rating. The maximum power supported by these regulators is 3.6 kW.


    TTC-2000, electronic controller for three-phase heating coils

    Electronic controllers for three-phase heating coils of the TTC-2000 series can have a power output of 16.5 kW. For higher power it is necessary to connect the TTS-1 (RA) module, which supports power up to 30kW. The electronic controllers for three-phase heating coils of the TTC-2000 series support main and minimum-maximum sensors. The external output signal is: 0-10V


    TG-R, ambient temperature sensors for use with electric battery controllers

    Ambient temperature sensors for use with electric battery controllers of the TG-R range are NTC type with linear increments. They have a set point temperature of 0-30ºC and protection class IP30. The TG-R 430 model has a setpoint temperature setting system, while the TG-R530 model does not have a setpoint temperature setting system.


    MCR-1, timer for resistor-supported ventilation systems

    The timers of the MCR-1 range have a setpoint value of between 1 second and 100 hours. These timers are used in resistance supported ventilation systems. Its job is to delay the fan shutdown, when the power is cut, to cool the coil.

Usos
  1. Accesorios (11)