PLUGFAN - ACCOPPIAMENTO A TRASMISSIONE
PFM

Plug fans are designed for applications where space is limited but it is required high airflow (clean or slightly dusty air) at low pressure inside ovens, booths or plenums. This range uses backward curved high efficiency impeller, manufactured without casing.
Produced in carbon steel protected against corrosion with primer spread with cataphoretic cycle + final layer of two-component water-based polyurethane enamel RAL 7045 based on acrylic resins.
Standard arrangements
- Arrangement 13B: arrangement 13 with cooling disk.
- Arrangement 13BC: arrangement 13 with cooling disk and insulated plate (60 mm. as standard, other thickness on request). Maximum air temperature up to 300ºC, special versions up to 450ºC.

Standard motors
2, 4, 6 poles IE3 high efficiency motors, three-phase 230/400V 50Hz up to motor size 132 and 400/690V 50Hz for higher motors.
IP55, Class F protection

On request
- Manufactured from different materials. Complete fan in stainless steel 304 or 316.
- 60Hz model available.
- Different painting RAL.
- Special executions.
- Static parts of the fan in hot dip galvanized.
- Solutions resistance against corrosion
- Wear proof construction.
- Special insulation.